Pulled fault codes found P0101 mass air flow circuit range 1 performance problem. Fault P0171 system too lean Bank 1 Fault Po174 system too lean Bank 2 Mass air flow dirty and slow to respond. Vacuum lines going to air box cracking, very brittle and separating. Serpentine belt squealing while driving vehicle into shop.
Guest states serpentine belt squeels.
AIR FLOW SENSOR – Remove & Replace
A/C COMPRESSOR DRIVE BELT – Remove & Replace – V6
HOOD SHOCKS OR STRUTS – Remove & Replace
Tom B. gave our service a 5 star review on 2/10/2025
Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures. Preform basic safety inspection.
Oil And Filter Environmental Disposal Fee
Lisa M. gave our service a 5 star review on 12/15/2024
Removed and repalced front pads and rotors. Sandblasted caliper brackets, cleaned caliper pins and slides. Lubed caliper pins and slides. Road tested burnish the pads in all Ok at this time.
Angel R. gave our service a 5 star review on 11/8/2024
Scanned the system and found code P2195 oxygen sensor lean fault B1S1. Removed O2 sensor B1,S1. Cleared the code test drove with scanner and found no existing code at this time.
AIR/FUEL RATIO SENSOR – Remove & Replace – V6 Upstream Oxygen Sensor,Right Side
Removed and replaced serpentine and drive belts. Test road no noise detected at start up or on road test.
POWER STEERING PUMP DRIVE BELT – Remove & Replace
ALTERNATOR DRIVE BELT – Remove & Replace – V6 – [Includes: Serpentine and V-Belt type Belt(s).]
Tom B. gave our service a 5 star review on 7/8/2024
Test drove and noted a braking pulsation. Inspected on the hoist and found the front and the rear brakes worn to 3-4 mm. Replaced the front and the rear brake pads with the rotors. Also cleaned and lubricated the caliper brackets to correct. Test drove and no pulsation noted at this time
Lisa M. gave our service a 5 star review on 6/10/2024